Logo

B0360 Engine Trouble Code

Meaning of B0360 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B0360 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for B0360 code is occuring now you should check B0360 repair processes.
Now don't ask yourself; What should you do with B0360 code ?
The solution is here :

B0360 Possible Solution:

B0360 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

B0360 Code Meaning :

B 0 3 6 0
OBD-II Diagnostic Body (B) Trouble Code For Engine Intake Valve Control Solenoid Circuit Low Throttle/Pedal Position Sensor/Switch A Circuit Intermittent Cylinder 4 Contribution/Balance Fault Shift Solenoid E Performance or Stuck Off

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

B0360 OBD-II Diagnostic Body (B) Trouble Code Description

B0360 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Main reason For B0360 Code

The reason of B0360 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.

B0360 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.